ElabNET Technik Forum

Code: Alles auswählen

{
  "Level": [
    ["$Alarm","bool",false],
    ["$Reset","bool",false],
    ["$State_1","bool",false],
    ["$State_2","bool",false],
    ["$State_3","bool",false],
    ["$State_4","bool",false],
    ["$State_5","bool",false],
    ["$Kurz","float",1.0],
    ["$Lang","float",2.0],
    ["$KonstTrue","bool",true],
    ["$VAR<Inhibit?>","bool",false]
  ],
  "Module": [
    ["Break",["$VAR<Inhibit?>"]],
    ["Monoflop","$Alarm",0,"$State_1","$Kurz",2],
    ["Monoflop","$State_1",0,"$State_2","$Kurz",4],
    ["Monoflop","$State_2",0,"$State_3","$Lang",4],
    ["Monoflop","$State_3",0,"$State_4","$Kurz",4],
    ["Monoflop","$State_4",0,"$State_5","$Kurz",4],
    ["Latch","-$KonstTrue","$Alarm","$State_5",2]     // setze am Ende den Alarm-Wert wieder zurück, damit ist der Eingang wieder scharf für das nächste mal 
  ],
  "Input": [
    ["Alarm","Start Alarmsignal","$Alarm","c"]
  ],
  "Output": [
    ["Signal","Klingelsignal","$KonstTrue","a"]
  ]
}